Piping & Layout Engineer Job description
Responsibilities
- Ensures the Piping & Layout engineering support to different projects In the case of call for tender:
- Ensures the achievement of assigned goals and the fulfillment of the project quality requirements and the contractual obligations.
- Analyzes the technical documents (specifications, calculation notes, drawings, etc.) in order to assess the scope of the studies required and the potential risks.
- Seeks as far as possible solutions which can bring overall savings to the project.
- Estimates quantities or validates estimation done by other specialist of the team.
- Checks all produced documents (internal or subcontracted) like design reports, technical specifications, drawings etc under his responsibility.
- Writes the Piping an Layout methodologies / Design Premises comprehensive of all necessary data, general and specific design guidelines (the technical roadmap for the discipline engineering activities).
In the case of project execution: - Ensures the achievement of assigned goals and the fulfillment of the project quality requirements and the contractual obligations.
- Analyze the project technical documents in order to validate consistency between the budget, resources and means allocated for the work completion and the targets to be met.
- Organizes the work of the team under his responsibility.
- Defines and follows-up the planning of resources mobilization.
- Monitors and reports actual progress including 3D / check for Discipline activities, including control of men-hours and delivered documents; particular care is required for sub-contracted activities.
- Writes the Piping and Layout methodologies / Design Premises comprehensive of all necessary data, general and specific design guidelines (the technical roadmap for the discipline engineering activities).
- Controls the input data for the team activities and check/review all the documents issued by the team
- Attends to internal review activities and inter-discipline check meetings.
- Provides technical support to Project group.
- Provides technical support to Procurement, Subcontracting and Construction activities included in the scope of work.
- Supervises the writing of specifications and requisitions as well as technical bid evaluations.
- Informs on a permanent basis the Project Piping and Layout leader of any foreseen technical or financial or delay risk.
- Feeds the Piping and Layout Department improvement system by reverting the lessons learned during the project.
Requirements
- Degree Mechanical Engineering
- Oil & Gas experience
- FEED experience
- Knowledgeable codes & standards